A cut tree is a plant on a clock. What actually grows in Louisiana, how to test a tree in the field, and the watering routine that keeps needles on it past New Year.
Louisiana Christmas Trees: How to Pick One That Lasts Past New Year
A cut tree is a plant on a clock. The day it comes down, the moisture it needs stops arriving, and everything after that is a race between how well it was grown, how it was handled, and how much water you are willing to carry. None of that is hard. Most of it just happens in a different order than people think.
What actually grows here
Louisiana does not have the fir belt, and it does not need one. The two varieties most Louisiana growers plant are Leyland cypress and Carolina Sapphire, and they behave differently enough to matter when you are standing in a field. The LSU AgCenter puts it plainly: Leyland cypress is the prettier tree and the more common one, but it is susceptible to a fungus that has to be sprayed on a schedule through the warm months. Carolina Sapphire holds up better in heat and drought, which is the reason some growers moved toward it.
What that means for you is simpler than it sounds. A tree that was irrigated through a dry summer is a tree with a better shot at holding its needles in your living room in January.
Ask where it was cut, not where it is from
The single most useful question at any lot is when the tree was cut. A choose-and-cut farm answers it by handing you a saw. A pre-cut lot answers it with a date, and if nobody there knows the date, that is your answer too. A tree that was cut six weeks ago in another state and trucked in is not a bad tree, but it started its clock before you ever saw it.
The freshness test, in order
Run your hand along a branch and pull it toward you. Needles should stay on. A few loose inner needles are normal on any cut tree. A shower of green is not.
Bend an outer branch between your fingers. Fresh cypress bends and springs back. Dry cypress snaps, and once it snaps it is not coming back.
Pick the tree up by the trunk and set it down on the pavement. A heavy tree for its size is holding water. A light one is holding air.
Look at the cut end of the trunk. It should look freshly sawn and pale, not gray and sealed over. A trunk that has dried and closed is a trunk that will not drink, no matter what you do with the stand.
Then smell it. Cypress has a clean, resinous smell that gets stronger when you crush a needle. If the tree smells like nothing, it is not telling you anything good.
Getting it home without ruining it
Have the lot net it. A netted tree takes a door frame and a stairwell without losing half its outer branches on the way in, and those outer branches are the shape.
If it is going on a roof, put it on the roof rack, not loose in the bed of a truck with a hand on it. Tie at the trunk and at the top. Drive slower than you want to. Wind at highway speed does the same thing to a tree that a week on a dry lot does.
Cut an inch off before it goes in the stand
This is the step people skip. Sap seals the cut within a few hours, and a sealed trunk cannot take up water. Take an inch off the bottom with a handsaw, straight across, and get it into water within an hour or two. Do not drill a hole, do not shave the sides, do not taper it. A clean straight cut and a stand with water in it is the whole trick.

Water is the entire game
Get a stand that holds more than you think you need. A tree can pull a surprising amount in the first two days, and the first two days decide how the rest of the month goes. Check the level twice a day for that first stretch. After that, once a day, every day, without exception. A tree that runs dry even once will seal its cut again and stop drinking.
Plain tap water is fine. The old advice about sugar, bleach, aspirin or soda is folklore with a downside: anything that makes the water less appealing to a thirsty tree is working against you.
Keep the tree away from heat. Fireplaces, space heaters, floor vents, radiators, televisions and anything else that pushes warm dry air into the room. The corner that looks best is often the corner next to the vent.
Lights matter more than people expect. LEDs run cooler than the old incandescent strings, and a cooler tree holds its moisture longer. Check the cord before it goes on the tree, and turn the lights off when nobody is in the room. A dry tree near a heat source is the exact combination that fire departments spend December warning about, and this is the month when the same dry air that cracks a house is pulling moisture out of the tree.
After the season
When the needles start dropping on their own, it is over. Get it out of the house. Do not burn it in the fireplace or a fire pit, because cypress sap pops and a dry tree goes up faster than wood, which is the reason most parishes run a separate tree pickup or a drop-off site in January. Check your parish's solid waste page for the dates.
If you want it to do something useful, a cut tree sunk in a pond makes cover for fish, and a chipped tree makes mulch. Both are better endings than the curb, and both require deciding before the truck comes.
The short version
Ask when it was cut. Bend a branch. Lift it. Look at the trunk. Net it, roof it, saw an inch off the bottom, water it twice a day for the first two days and once a day after, keep it away from heat, and take it down when it starts dropping. That is the whole difference between a tree that makes it to January and a tree that is on the curb by the 28th.
While you are decorating, the yard has its own November business to finish. Your Pecans Are Ready Before You Think They Are covers the drying and storage part that almost nobody does.
More from 337 Magazine: Your Pecans Are Ready Before You Think They Are · The Cold Snap Playbook: What Breaks in an Acadiana House at 28 Degrees · Events


